Profile Modeler Update Error

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Profile Modeler Update Error

Postby Brian Shannon » Mon, Jul 31 2006, 11:17AM

I'm getting this message when installing the new Profile Modeler Update.

Ryan Hochgesang

Postby Ryan Hochgesang » Tue, Aug 01 2006, 8:14AM

Hi Brian,

I am checking into this issue for you and will contacted you as soon as I get some information.

Thanks for your patience.

Ryan Hochgesang

Postby Ryan Hochgesang » Tue, Aug 01 2006, 9:38AM

Brian,

You will want to look into the following in order to resolve this issue:

1.) Check designated path for existing files, delete if old files exist, then replace with new files. (The new files may be unable to copy over existing, due to Read only attributes of existing files.)

2.) Make sure that there is enough hard drive space left on C:\\ (approx. 100 MG needed) If there is not enough space or amount is limited, it would be a good idea to perform Defragment and Disk Cleanup on computer to safely remove unnecessary data.


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: Yahoo [Bot] and 6 guests