G901 Settings Off

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Zach Froble
Senior Member
Posts: 171
Joined: Tue, Jun 21 2005, 3:23PM
Location: Connellsville, PA

G901 Settings Off

Postby Zach Froble » Mon, Aug 14 2006, 4:06PM

I adjusted my 901 settings to run some custom mouldings that I had to fixture. My problem now is that even though I changed them back they are not correct. I checked them several times to make sure it took the changes back to my normal.

Thanks,

Zach
Lyndan Designs
Machining and CAD Services

Dave Burtchell
Junior Member
Posts: 98
Joined: Thu, Jun 30 2005, 10:04PM

Postby Dave Burtchell » Tue, Aug 15 2006, 4:32PM

Zack,

Don't forget to drop down to the last line and hit the start button, or is it the block step + button? Anyway, if you don't do this, your changes won't be saved. Just a thought.

Dave

Zach Froble
Senior Member
Posts: 171
Joined: Tue, Jun 21 2005, 3:23PM
Location: Connellsville, PA

Postby Zach Froble » Wed, Aug 16 2006, 9:14AM

I thought I had already done that, but that evening I went back and tried it again and everything seems to be working fine now. Thanks for the reply though.

Zach
Lyndan Designs

Machining and CAD Services


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 1 guest