Hello,
We are trying to run the attach Book case on the CNC. The Cabinet was drawn in E-Cabinets V5. The CNC was able to drill all the shelf holes and started to do the Blind dato. Once it went to do the outline for the Adj. Shelfs, an error came up Line 321 \"Invalid Syntax in program Error 3529\" Line 321: G01X16.5374Y12.26502--0.2100F200.00
The Material thickness
Top of unit is 1.1875 Thick
Bottom of Unit is 1.1875 Thick
Sides and Adj. Shelf are 0.72 Thick
Any help would be greatly appreciated!
Thanks,
Dave
Invalid Syntax Error 3529
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
Invalid Syntax Error 3529
- Attachments
-
- Bookcase.jpg (38.17 KiB) Viewed 6091 times
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
Hi Dave,
If you can email me the hsf file for this cabinet and the cnc file I will take a look at the problem. I think I know what the problem (bug) is but I want to make sure. My email is cabinets@thermwood.com
thanks,
If you can email me the hsf file for this cabinet and the cnc file I will take a look at the problem. I think I know what the problem (bug) is but I want to make sure. My email is cabinets@thermwood.com
thanks,
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
Hi Dave,
Just to let you know is the skin thickness is the amount that it leaves. For example if you are cutting material that is .72 and your skin thickness is set to .70 you are only cutting .02 on the first pass and the rest on the second pass. Normally you want to set this low like .03. This way it will cut .69 deep on the first pass and then the remaining .03 on the second pass.
Just to let you know is the skin thickness is the amount that it leaves. For example if you are cutting material that is .72 and your skin thickness is set to .70 you are only cutting .02 on the first pass and the rest on the second pass. Normally you want to set this low like .03. This way it will cut .69 deep on the first pass and then the remaining .03 on the second pass.