Discuss Thermwood 3-axis Machinery, Controller, and Software.
3 posts • Page 1 of 1
- Senior Member
- Posts: 121
- Joined: Mon, Jun 13 2005, 12:26PM
- Location: Calverton, New York
I purchased the tooling to do dovetail drawers on our CS-45 using the new capabilities provided in version 5 of eCabinets software. I can't seem to find any reference to how the tooling should be set up in the router so that it differentiates a 1/2\" dove tail tool from any other 1/2\" bit. Any suggestions?
Woodworking the Way You Want It
- Jason Susnjara
- Thermwood Team
- Posts: 1723
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
Who is online
Users browsing this forum: No registered users and 8 guests