this is so old

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

this is so old

Postby Jeff Norris » Sat, Sep 09 2006, 1:36PM

wonder what would happen if i ran this program
Attachments
bad nest.jpg
bad nest.jpg (68.17 KiB) Viewed 1052 times
more bad nests 2.jpg
more bad nests 2.jpg (71.64 KiB) Viewed 1052 times

Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Postby Jeff Norris » Sat, Sep 09 2006, 1:37PM

more
Attachments
more bad nests 3.jpg
more bad nests 3.jpg (81.83 KiB) Viewed 1051 times

Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Postby Jeff Norris » Sat, Sep 09 2006, 3:43PM

spend another hour of my life, delete all the edge banding and now it will nest. this is great!

Forrest Chapman
eCabinets Beta Tester
Posts: 1078
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Postby Forrest Chapman » Sat, Sep 09 2006, 7:09PM

Jeff,

I found most of the time these are just graphic issues. Did you write the code and check it?

Forrest

Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Postby Jeff Norris » Sun, Sep 10 2006, 10:29AM

this is no graphic issue just ecabinets


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 1 guest