this is so old

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

this is so old

Post by Jeff Norris »

wonder what would happen if i ran this program
Attachments
bad nest.jpg
bad nest.jpg (68.17 KiB) Viewed 6304 times
more bad nests 2.jpg
more bad nests 2.jpg (71.64 KiB) Viewed 6304 times
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

more
Attachments
more bad nests 3.jpg
more bad nests 3.jpg (81.83 KiB) Viewed 6303 times
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

spend another hour of my life, delete all the edge banding and now it will nest. this is great!
Forrest Chapman
eCabinets Beta Tester
Posts: 1230
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Post by Forrest Chapman »

Jeff,

I found most of the time these are just graphic issues. Did you write the code and check it?

Forrest
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

this is no graphic issue just ecabinets
Post Reply