problems with barcodes

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Mark Hesketh
Guru Member
Posts: 365
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

problems with barcodes

Postby Mark Hesketh » Thu, Sep 28 2006, 6:39AM

since i installed the new update for the control nesting software, i seem to be unable to scan in any barcodes that are generated since the update for offcuts... is this a widespread issue or just me?

User avatar
Larry Epplin
Thermwood Team
Posts: 645
Joined: Tue, May 17 2005, 12:44PM
Location: Thermwood

Postby Larry Epplin » Fri, Sep 29 2006, 1:08PM

We have found the problem and will have an update out next week to address it. For now if you need to load a particular Off-Fall you can do it through the dialog reached through the OffFall button. Just find the matching number and click load. You can also type it in while in the Add Sheet dialog. You must type the entire string. For example with the following string...

$-223562589$

You must include the $ when typing. Once you enter the last $ the Off-Fall will appear.

Mark Hesketh
Guru Member
Posts: 365
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

Postby Mark Hesketh » Sat, Sep 30 2006, 12:13PM

hey, thanks for attacking the problem so quickly. your temporary solution has a problem as well though... i can't even find the off-fall number in the appropriate dialogue. i will try typing it in directly next time and see if that works, but they aren't appearing in the off-fall list when i look there.

thanks again


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 2 guests