ecab or control nest problem

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Mark Hesketh
Guru Member
Posts: 363
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

ecab or control nest problem

Postby Mark Hesketh » Mon, Oct 02 2006, 8:43AM

i am not sure if this is being caused by the new version of ecab or the new version of the control nesting software, or a combination of the two. in the past, the 1/2 inch rabbet at the back of the gables for the backs was always cut with our 1/2 inch dia bit. as far as i know, i have not changed any settings other than to upgrade version of both software, but now those rabbets are all being cut with our 3/8 inch dia bit, which tends to dull alot faster. any ideas how i can get it to go back to using the 1/2 inch dia bit?

User avatar
Jason Susnjara
Thermwood Team
Posts: 1722
Joined: Tue, May 10 2005, 1:26PM
Location: Thermwood
Contact:

Postby Jason Susnjara » Mon, Oct 02 2006, 9:42AM

Hi Mark,

Can you email me a couple of files?

I would like the machine.ini and tools.thm These are located on the controller under C:\\Rolling Nest folder.

If you can also send the .esj file of cabinet file so I can take a look at these.

My email is cabinets@thermwood.com

thanks,


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: Bing [Bot] and 5 guests