off fall nesting over parts

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Matt Beaty
New Member
Posts: 12
Joined: Mon, Dec 26 2005, 1:08PM
Location: Minden , Nevada
Contact:

off fall nesting over parts

Postby Matt Beaty » Fri, Oct 13 2006, 10:24AM

I have been running into a nesting issue where the off fall from my machine is cutting into my parts when it outlines. Sometimes it shows on the sheet printouts and sometimes it doesn't. This is becoming costly as it mainly happens on finished end material. Does anyone have any suggestions? Attatched is the twd. file for a looksee.

User avatar
Larry Epplin
Thermwood Team
Posts: 644
Joined: Tue, May 17 2005, 12:44PM
Location: Thermwood

Postby Larry Epplin » Fri, Oct 13 2006, 1:03PM

Matt,

Please post your machine.ini & tools.thm They are located in the c:\\Rolling Nest directory.

Larry


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 1 guest