off fall nesting over parts

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Matt Beaty
New Member
Posts: 12
Joined: Mon, Dec 26 2005, 1:08PM
Location: Minden , Nevada
Contact:

off fall nesting over parts

Post by Matt Beaty »

I have been running into a nesting issue where the off fall from my machine is cutting into my parts when it outlines. Sometimes it shows on the sheet printouts and sometimes it doesn't. This is becoming costly as it mainly happens on finished end material. Does anyone have any suggestions? Attatched is the twd. file for a looksee.
Larry Epplin
Thermwood Team
Posts: 668
Joined: Tue, May 17 2005, 12:44PM
Location: Thermwood

Post by Larry Epplin »

Matt,

Please post your machine.ini & tools.thm They are located in the c:\\Rolling Nest directory.

Larry
Post Reply