off fall nesting over parts
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- New Member
- Posts: 12
- Joined: Mon, Dec 26 2005, 1:08PM
- Location: Minden , Nevada
- Contact:
off fall nesting over parts
I have been running into a nesting issue where the off fall from my machine is cutting into my parts when it outlines. Sometimes it shows on the sheet printouts and sometimes it doesn't. This is becoming costly as it mainly happens on finished end material. Does anyone have any suggestions? Attatched is the twd. file for a looksee.
-
- Thermwood Team
- Posts: 668
- Joined: Tue, May 17 2005, 12:44PM
- Location: Thermwood