Inset handle route
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
Inset handle route
Hi Everyone,
I am trying to route a slot for an applied inset handle. The CNC is leaving alittle bit left over in the center. The cabinet was drawn in e-cabinets, i am not sure if this is a ecabinets issue or a Thermwood CNC setting. Any help would be greatly appreciated.
Thanks,
Dave
I am trying to route a slot for an applied inset handle. The CNC is leaving alittle bit left over in the center. The cabinet was drawn in e-cabinets, i am not sure if this is a ecabinets issue or a Thermwood CNC setting. Any help would be greatly appreciated.
Thanks,
Dave
- Attachments
-
- PA270002.JPG (94.92 KiB) Viewed 8908 times
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
Hi Dave,
Can you also post the .hsf file for this part in eCabinets or you can email it to cabinets@thermwood.com?
thanks,
Can you also post the .hsf file for this part in eCabinets or you can email it to cabinets@thermwood.com?
thanks,
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
-
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
-
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact: