Warning - DXF users - Nasty bug.

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

David Hall
eCabinets Beta Tester
Posts: 588
Joined: Tue, May 17 2005, 12:41PM
Location: Stamford, CT USA
Contact:

Warning - DXF users - Nasty bug.

Postby David Hall » Wed, Nov 22 2006, 2:47PM

I have had two sheets of material end up in the dumpster from this one.

CN 5.07
DXF files
Chain compout layer
Climb cutting

When CN happens to pick a small clockwise arc (any size arc?) portion of the chain to start the cut on, the arc is cut in the counter clockwise; taking a chunk out of the part.

Why doesn't this stuff happen when I'm cutting the cheap stuff?

Regards,
Dave
David Hall
Hall's Edge Inc.
eCabinets Machining Services
http://www.HallsEdge.com

User avatar
Larry Epplin
Thermwood Team
Posts: 644
Joined: Tue, May 17 2005, 12:44PM
Location: Thermwood

Postby Larry Epplin » Mon, Nov 27 2006, 11:26AM

This is addressed in version 5.08.


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 5 guests