I have had two sheets of material end up in the dumpster from this one.
CN 5.07
DXF files
Chain compout layer
Climb cutting
When CN happens to pick a small clockwise arc (any size arc?) portion of the chain to start the cut on, the arc is cut in the counter clockwise; taking a chunk out of the part.
Why doesn't this stuff happen when I'm cutting the cheap stuff?
Regards,
Dave
Warning - DXF users - Nasty bug.
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
-
- Thermwood Team
- Posts: 668
- Joined: Tue, May 17 2005, 12:44PM
- Location: Thermwood