Has anyone ran into this problem before.
All cabinets created in Build 10, and they all have blind dado contruction. They are no part editor cuts on any of them. But when I go to nest in CN 5.08 it is treading all my dados as pockets and it wants that correct diameter of tooling to do so. I have never run into this before and was wondering if any one else has.
Thanks,
Zach
Dados being treated as pockets
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Senior Member
- Posts: 171
- Joined: Tue, Jun 21 2005, 3:23PM
- Location: Connellsville, PA
Dados being treated as pockets
Lyndan Designs
Machining and CAD Services
Machining and CAD Services
-
- Guru Member
- Posts: 828
- Joined: Fri, Jun 17 2005, 12:23AM
- Location: South Africa
-
- Senior Member
- Posts: 171
- Joined: Tue, Jun 21 2005, 3:23PM
- Location: Connellsville, PA
-
- Guru Member
- Posts: 828
- Joined: Fri, Jun 17 2005, 12:23AM
- Location: South Africa