for some reason today, the router doesn't like me too much. it cut one sheet fine, but as soon as it tries to run the next sheet, i get a \"z axis out of bounds\" error as soon as it tries to drill the first hole. i have done everything i can think of, including deleting the gang-drill from the tool setup to force it to use the single drill, but the same error message pops up every time. i just updated to cn5.10 last night, could that be the problem? if so, how do i revert to a previous version?
please help!
z axis out of bounds???
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario
-
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario
more on this problem...
it appears to be a problem with the version 10 update. a job that was compiled before i updated still runs fine, but the job compiled after the update craps out every time.
the \"z axis out of bounds\" is apparently happening because it wants to drill the holes 11.7274 inches into my table!!! why? i don't know.
still hunting for a solution
it appears to be a problem with the version 10 update. a job that was compiled before i updated still runs fine, but the job compiled after the update craps out every time.
the \"z axis out of bounds\" is apparently happening because it wants to drill the holes 11.7274 inches into my table!!! why? i don't know.
still hunting for a solution
-
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario
ok, after some more examination, it turns out that the problem is not with the entire job, but just with the gables for one cabinet in the job... just happens to be the first thing it wants to drill. the rest of the code appears to be alright. so now i am guessing that this is som eproblem in communication between ecab and control nesting...
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
-
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario