Making miter cuts

Roger Erismann · Post by **Roger Erismann** » Thu, Mar 08 2007, 11:47PM

Whats the deal with making miter cuts? when I ask if it's possible in ecabs..the inevitable answer is no...but I see plenty of V groove and miter bits available for the CNC...

I made a \"miter tool\" and the profile modeler copied it...

This is reference doing 45 mitre on panels that would be assembled later...like returns on wall panles or large cases...

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Sat, Mar 10 2007, 1:15AM

I was just tinking about this. It would be posible in Profile Modeler. The cnc operator woud probably have to set the bit as a costum bit. We coud probably try this next week !!!