We seem to be having a problem very recently with our dove tail drawer boxes. It seems the final outline cut ignores the wasteboard thickness and leaves an onion skin approximately the thickness of the waistboard. Around the dovetails however it is cut cleanly to the table. In watching the final outline cut the depth was 0.627 (Z dimension) which on a 5/8\" thick drawer will leave you too high. If our wasteboard is 0.23, I would think the depth of this cut should be 0.857. We recently upgraded to rolling nest 5.22
Any insights would be much appreciated.
Dove Tail Drawer Box Issue
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Senior Member
- Posts: 121
- Joined: Mon, Jun 13 2005, 12:26PM
- Location: Calverton, New York
- Contact:
Dove Tail Drawer Box Issue
Woodworking the Way You Want It
-
- Senior Member
- Posts: 121
- Joined: Mon, Jun 13 2005, 12:26PM
- Location: Calverton, New York
- Contact: