Discuss Thermwood 3-axis Machinery, Controller, and Software.
Moderators: Jason Susnjara , Larry Epplin , Clint Buechlein , Jim Bullis
Nemanja Vujkovic
Senior Member
Posts: 222 Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO
Post
by Nemanja Vujkovic » Fri, Mar 16 2007, 5:31PM
CNC is cutting too deep on outline cuts. Dados and holes are fine it's just outline cuts.
Does anyone have a recomendation?
Thank you!
Joe Soto
Guru Member
Posts: 367 Joined: Thu, May 19 2005, 7:50PM
Company Name: Fancyridge Wood Products LLC
Location: Greensburg, Ky
Post
by Joe Soto » Fri, Mar 16 2007, 7:30PM
Nemanja, Check to see if you cut through depth has been changed somehow, also if you use the outline tool only for outlines, the tool length may be off.
Joe
Nemanja Vujkovic
Senior Member
Posts: 222 Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO
Post
by Nemanja Vujkovic » Fri, Mar 23 2007, 9:56AM
sorry i could not answer earlyer
it seams that the bit started walking out of the tool holder due to hiting
thanks