I've made MDF Doors in Profile Modeler. Now I have a need for a quick door. I bought a Whiteside 3750 bit. How do I make the router make two passes in a conventional direction so the cut is cleaner than just a single pass? Do I just make my tool dia. in tooling setup a little smaller than it is in eCab .tol ?
Brian
MDF Doors
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
-
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
-
- Guru Member
- Posts: 309
- Joined: Sat, Feb 04 2006, 5:13PM
- Location: Hilton Head / Bluffton SC
See Ryan's response to a similar question I had...
http://www.thermwood.com/forums/viewtopic.php?t=5258
Mark
http://www.thermwood.com/forums/viewtopic.php?t=5258
Mark