5 Piece door

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Chris B Campbell
Junior Member
Posts: 84
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

5 Piece door

Postby Chris B Campbell » Sun, Apr 08 2007, 4:06PM

Has anyone run this yet? Any comments? We spend a small fortune on door and drawer fronts so we are seriously looking at this option for our CS40.


Nemanja Vujkovic
Senior Member
Posts: 222
Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO

Postby Nemanja Vujkovic » Tue, Apr 10 2007, 8:23AM

We ran some, but we just did the panels, stiles and rails we ran on shaper!

Todd Miller

Postby Todd Miller » Thu, Apr 12 2007, 3:24PM

We have been running them successfully at our trade shows. Although, you probably want comments from other customers. But, if you have any specific questions, feel free to ask!

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 7 guests