Edgebanding logo an stickers for backs

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Ryan Osburn
New Member
Posts: 3
Joined: Fri, Mar 16 2007, 3:43PM

Edgebanding logo an stickers for backs

Postby Ryan Osburn » Fri, May 25 2007, 3:04PM

Iam getting the edgebanding logo on cabnets and drawers for there backs even though I dont have edgebanding on any part of the drawer. its not all of them it seems to be just evry now and then why?
Picture 004.jpg
Picture 004.jpg (154.67 KiB) Viewed 735 times

Todd Miller

Postby Todd Miller » Tue, May 29 2007, 7:42AM

Have you checked in the Edgebanding editor to see if the edgebanding has been applied to those areas or not? If so, post the cabinet and we can take a look at it. Thanks!

Also, what version of Control Nesting are you running?

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 7 guests