tool lockout switch, siemens IR module fault

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

SoulDiallo
New Member
Posts: 8
Joined: Tue, Jun 26 2007, 3:55PM

tool lockout switch, siemens IR module fault

Postby SoulDiallo » Thu, Jul 19 2007, 3:40PM

Please advice about how to definitely clear this fault.

It happens sometimes after NC reset has been pressed.

When cleared by clicking OK the machine works fine except the E-stop on the teach pendant does not work.

I have a M67DT

Thanks.

Jason McDaniel
Thermwood Team
Posts: 16
Joined: Tue, Mar 20 2007, 7:39AM
Location: Thermwood

Postby Jason McDaniel » Fri, Jul 20 2007, 8:02AM

Hello,
Does the error come up when you press NC Reset or when you press the front panel e-stop button in? This is common to see when pressing the front panel stop in because it is tied into the same circuit as the tooling lockout switch. You can delete the PLC history file in the System folder of the C: drive to see if that helps. To really troubleshoot the problem you would want to talk to someone in the field service department at Thermwood on the phone. 1-800-221-3865
Jason McDaniel
Machine Support Group


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 5 guests