Building Stairs

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Bill OConnell
Senior Member
Posts: 121
Joined: Mon, Jun 13 2005, 12:26PM
Location: Calverton, New York
Contact:

Building Stairs

Post by Bill OConnell »

Does anyone know of any programs to allow the cutting of stair parts on a CNC machine?

Thanks.
Woodworking the Way You Want It
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

mastercam has a macro for cutting stair stringers, it will also cut both stringers for an open riser stair case, miter the returns and everything.
Forrest Chapman
eCabinets Beta Tester
Posts: 1231
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Post by Forrest Chapman »

Hey Bill again,

There are cadspecific stair programs out. However out of respect for this forum I'd rather not say who it is. Do a simple search and it should popup.

Forrest
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

thermwood sells mastercam
Post Reply