Upgrade please

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand

Upgrade please

Post by Paul Ford »

Hi all!
Just wondering if we could please have a RN update which shows off falls in the right place when nesting a job? We managed to have a look through the forum to see where the machine is cutting these parts. It looks like it is cutting off falls from G901 but still shows it from the home location on the bed. Would save us alot of confusion and board if we knew it had been changed in the first place.
Thanks,
Paul.
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

i have no idea where my machine is trying to cut offalls after uprading to RN 4.71 i was hopeing it was g901 but mine is doing somthing completly diffrent.
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand

Post by Paul Ford »

Anything?? Nothing?? Pretty please with ecabs on top?
Jason Susnjara
Thermwood Team
Posts: 1721
Joined: Tue, May 10 2005, 1:26PM
Location: Thermwood
Contact:

Post by Jason Susnjara »

Hi Paul,

I belive that there are other postings on this site that explain the offalls. We don't show it yet in the nesting area but offalls can be located in the G901 location as well as being able to rotate the offall in any direction. I will get some more info on this after I talk to the programmers.

thanks,
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand

Post by Paul Ford »

Hi Jason,
Thanks for that. So when the parts are rotated are they still located in the G901 position?
Jason Susnjara
Thermwood Team
Posts: 1721
Joined: Tue, May 10 2005, 1:26PM
Location: Thermwood
Contact:

Post by Jason Susnjara »

Yes they are
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand

Post by Paul Ford »

YAY!! Thank you!!
Post Reply