Another possible addition for Rolling Nest

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Nick M Singer
Guru Member
Posts: 828
Joined: Fri, Jun 17 2005, 12:23AM
Location: South Africa

Another possible addition for Rolling Nest

Postby Nick M Singer » Tue, Sep 13 2005, 9:58AM

Another thing that may be useful for users of Rolling nest is to be able to tell the system to make more than one pass depending on the thickness of the material being cut, viz if I were cutting 30mm MDF I could set up to make 2 passes or 3, whatever the material dictated.

User avatar
Bill Rutherford
eCabinets Beta Tester
Posts: 386
Joined: Tue, May 10 2005, 5:23AM
Location: Lancaster, NH
Contact:

Postby Bill Rutherford » Tue, Sep 13 2005, 12:37PM

I know we have covered this ground in the past, but for the record I second, third, and fourth this request. :D :D :D (Hope I am allowed to vote more then once)

Bill R


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: Google [Bot] and 6 guests