problems with CN 5.43

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Mark Hesketh
Guru Member
Posts: 366
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

problems with CN 5.43

Postby Mark Hesketh » Tue, Nov 18 2008, 6:32AM

Installed 5.43 a few days ago and ran into a problem with pocket cuts. On SOME, not all, of the pockets, the cutter runs half the diameter of the cutter into the part when running the cleanup pass, resulting in a clean pocket, with a half circle cut into the material at one end of the pocket.

Also, after updating CN, I discovered that my tool group settings had all been deleted. All of my material-specific tool setups are now gone.

I have had to revert to a previous version in order to get pockets to consistently cut correctly.

Ryan Hochgesang

Re: problems with CN 5.43

Postby Ryan Hochgesang » Tue, Nov 18 2008, 3:37PM

Mark,

We are currently looking into this situation, however, if you'd please send your supporting files to program@thermwood.com we can also use your files for testing. We would like to see your design file along with the Export from control nesting.

Thanks!

User avatar
Georgi Baltov
Guru Member
Posts: 341
Joined: Sat, Mar 10 2007, 7:31PM
Company Name: Top Notch Cabinets
Country: CANADA
Location: Oakville, Ontario
Contact:

Re: problems with CN 5.43

Postby Georgi Baltov » Fri, Nov 21 2008, 11:35AM

Wow, this is going bad. I haven't nested anything with 5.43 yet. Only a couple of sheets with dovetail dbxs. I will revert to 5.41 tough. Don't want to risk it. Too many ppl found all different bugs.


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 6 guests