Dovetail tool deph problem
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- eCabinets Beta Tester
- Posts: 276
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Dovetail tool deph problem
My dovetail tool always goes into the material a little too much, that reults in a little gap on the drawer edge and we have to apply a little bit of putty and sand it. Do I solve this issue with the radius crunch into the control nest settings ? Mine is set at 0.06". Thank you.
-
- eCabinets Beta Tester
- Posts: 1236
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: Dovetail tool deph problem
Dan,
You can slightly adjust the daylight value on that tool. You need to subtract from the daylight value in order to get a shallower cut. I have found the best results are to leave a very small edge just skimming the surface.
Hope this helps,
Forrest
You can slightly adjust the daylight value on that tool. You need to subtract from the daylight value in order to get a shallower cut. I have found the best results are to leave a very small edge just skimming the surface.
Hope this helps,
Forrest
-
- Guru Member
- Posts: 341
- Joined: Sat, Mar 10 2007, 7:31PM
- Company Name: Top Notch Cabinets
- Country: CANADA
- Location: Oakville, Ontario
- Contact:
Re: Dovetail tool deph problem
Dan,
what kind of material are you using for your dovetail dbxs? The one we use is Russian Baltic birch and is really good material, the only issue is that is varies a lot in thickness. I usually let the bit cut deeper and then I just put the parts through the drum sander until I get a nice joint. One good thing about that is that then the inside of the box doesn't need to be sanded and saves lots of time for the finishers.
We tried different materials that are more consistent but then they lack the structural stability.
That's our workaround. Hope it helps
what kind of material are you using for your dovetail dbxs? The one we use is Russian Baltic birch and is really good material, the only issue is that is varies a lot in thickness. I usually let the bit cut deeper and then I just put the parts through the drum sander until I get a nice joint. One good thing about that is that then the inside of the box doesn't need to be sanded and saves lots of time for the finishers.
We tried different materials that are more consistent but then they lack the structural stability.
That's our workaround. Hope it helps
Top Notch Cabinets
http://www.topnotchcabinets.com/
http://www.topnotchcabinets.com/