Timer

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

User avatar
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Country: NEW ZEALAND
Location: Christchurch New Zealand
Contact:

Timer

Postby Thom Davies » Tue, Dec 02 2008, 3:04PM

Hey How's it going?

With the timer on the therm does it time when the machine starts till finish including being idle or is it the time it has been cutting for?

Thanks

Thom Davies
[url=http://www.colinmcraesport.com]
Image
[/url]

Ryan Hochgesang
Thermwood Team
Posts: 681
Joined: Wed, May 18 2005, 8:41AM
Location: Thermwood

Re: Timer

Postby Ryan Hochgesang » Tue, Dec 02 2008, 4:50PM

Hi Thom,

The sub timer programs available on the Thermwood track all time between the time the START timer is executed, until the END timer is called.
Ryan Hochgesang
Software Support

Michael J Starry
Junior Member
Posts: 29
Joined: Tue, Oct 03 2006, 9:40AM
Location: Brainerd, MN
Contact:

Re: Timer

Postby Michael J Starry » Wed, Dec 03 2008, 2:06PM

So, to elaborate on Ryan's post...

If you call up the START at the beginning of the program and END at the end, above the M02 it will only time the amount of time the machine is running/cutting

If you are looking to time button to button cycles so you can have time for part removal, cleanup, etc between pressing the go button you can put the ENDTIME above the STRTIME at the top of the program. Then the machine will not call the END until the operator hits the go button again. We do both here. I run it with the start at top and end at the end to get actual machining time for quoting purposes. Then I run it with END above START for an hour or 2 to get an accurate button to button time for scheduling purposes.

User avatar
Damon Nabors
eCabinets Beta Tester
Posts: 923
Joined: Wed, Apr 05 2006, 5:50PM
Location: Marion, Ar.
Contact:

Re: Timer

Postby Damon Nabors » Wed, Dec 03 2008, 11:39PM

Good information Mike, Thanks for the input. I had wondered about the timer also.
Damon Nabors


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 6 guests