Egdetape Thickness on Label

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

User avatar
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Location: Christchurch New Zealand

Egdetape Thickness on Label

Postby Thom Davies » Wed, Dec 03 2008, 5:41PM

Hey How's it going?

Just wondering if there any chance soon that we could get what thickness tape goes on a part on a label. When we run white board jobs there might be serval jobs in that nest and be quick and less waste if we could have on the label what thickness tape goes on. 1mm and 2mm tape is what we use


Thom Davies

User avatar
Larry Epplin
Thermwood Team
Posts: 652
Joined: Tue, May 17 2005, 12:44PM
Location: Thermwood

Re: Egdetape Thickness on Label

Postby Larry Epplin » Thu, Dec 04 2008, 9:31AM

Yes, this is something we have been planning to implement for quite some time. The hold on the development has been due to the need to implement customizing the label layout. This will allow a user to adjust for different size labels as well as add/remove parameters without the need for Crystal Reports. This development effort is taking some time. Thank you for your patience.

User avatar
Neville Bastian
Guru Member
Posts: 598
Joined: Fri, May 20 2005, 6:48PM
Company Name: Classic Cabinetry
Location: Albany Western Australia

Re: Egdetape Thickness on Label

Postby Neville Bastian » Fri, Dec 05 2008, 10:44PM

Hi Larry,
This issue is pretty important and I can understand the complexity of creating this report without using crystal reports. Could you not deliver this result in two stages? Stage one you have to use crystal reports to get the edging thickness, edge colour and edge finish. Stage two you have a built in label designer.
If this label had a built in bar code like the offcuts has printed that we could run a scanner over at the edgebander that would be mickey mouse.
From memory I think we have this information already going into ecabinets so it may not be that difficult to get it to show up on the label?

Sorry for harping on this but we have just come from a legacy system with this info available to us on the labels to Ecabinets system so feel at a loss.


Neville Australia

Senior Member
Posts: 170
Joined: Sat, Oct 22 2005, 10:59AM
Location: Spartanburg, SC

Re: Egdetape Thickness on Label

Postby BenRatt » Tue, Dec 30 2008, 8:49AM

I second the ability to customize labels. I would love to have the ability to color code labels and be able to print barcodes on them. Thanks
Ben Ratterree
Blue Ridge Cabinetworks
Spartanburg, SC

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 4 guests