I upgraded to RN 5.44. I have a job that I was able to cut all my materials but one when I use the material filter and I get this message when I try to nest this material alone : "Not a valid password". If I nest the whole job I get : "Getrows binding error. Probably caused by datatype mismatch."
I attached the .twd.
Thank you.
Problem nesting a job
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- eCabinets Beta Tester
- Posts: 276
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Problem nesting a job
- Attachments
-
- etiquette blanche.txt
- (162 KiB) Downloaded 276 times
Re: Problem nesting a job
Dan
Does this job have doors and drawer fronts in it? If so, did you group them?
Does this job have doors and drawer fronts in it? If so, did you group them?
-
- eCabinets Beta Tester
- Posts: 276
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Re: Problem nesting a job
Yes it does have doors and they are grouped
-
- eCabinets Beta Tester
- Posts: 276
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Re: Problem nesting a job
Is another job problem. I get : "Error opening Nestlib. Exiting..."
- Attachments
-
- Kitchen maple.txt
- (392 KiB) Downloaded 268 times
Re: Problem nesting a job
Dan
If your still having problems after our phone conversation yesterday, please let me know.
If your still having problems after our phone conversation yesterday, please let me know.
-
- eCabinets Beta Tester
- Posts: 276
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Re: Problem nesting a job
I got back to 5.41 so now I'm ok, waiting for 5.45