MELAMINE AND RAMPING

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Zach Froble
Senior Member
Posts: 171
Joined: Tue, Jun 21 2005, 3:23PM
Location: Connellsville, PA

MELAMINE AND RAMPING

Postby Zach Froble » Thu, Sep 22 2005, 11:57AM

I have been experiencing some problems when cutting melamine panels. I am using a 1/2\" compressing spiral and while the cutter is ramping the up-cut on the bit is chipping the melamine.

I was wondering what everyone else was doing about this. I thought about not ramping and just plunging into the cut, could someone tell me what the setting should be in rolling nest to stop the ramping or any other suggestions that help.

Thanks

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 3 guests