Something is off with outline cut
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
Something is off with outline cut
I am cutting a cabinet and outline is way off. It is not rectracting to the specified hight.
- Attachments
-
- ControlNest5-47.zip
- export file
- (54.95 KiB) Downloaded 308 times
-
- openCab.zip
- .cnc file
- (1.77 KiB) Downloaded 302 times
-
- openCab.zip
- .esj file
- (455.67 KiB) Downloaded 307 times
-
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
Re: Something is off with outline cut
I think that i figured it out. I looks like that when the material ticknes and max penetration are the same value ( in my case .8" for both) the cnc does not rectract to the specifide hight. Can anyone verify this?
Thank You.
Nemanja
Thank You.
Nemanja
-
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
Re: Something is off with outline cut
Hi everyone,
I was just wondering what was figured on the problem I had. Am i correct in my asamption?
I was just wondering what was figured on the problem I had. Am i correct in my asamption?
-
- Thermwood Team
- Posts: 361
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: Something is off with outline cut
You are correct. There is an issue with depth cuts right now. If your material thickness is greater than or equal to your max penetration, it does not finish the operation properly. The software engineers know of this issue so it should be fixed in the next release of Control Nesting.
-
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
Re: Something is off with outline cut
Thank you Daniel.
Nemanja
Nemanja