Something is off with outline cut

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Nemanja Vujkovic
Senior Member
Posts: 222
Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO

Something is off with outline cut

Post by Nemanja Vujkovic »

I am cutting a cabinet and outline is way off. It is not rectracting to the specified hight.
Attachments
ControlNest5-47.zip
export file
(54.95 KiB) Downloaded 308 times
openCab.zip
.cnc file
(1.77 KiB) Downloaded 302 times
openCab.zip
.esj file
(455.67 KiB) Downloaded 307 times
Nemanja Vujkovic
Senior Member
Posts: 222
Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO

Re: Something is off with outline cut

Post by Nemanja Vujkovic »

I think that i figured it out. I looks like that when the material ticknes and max penetration are the same value ( in my case .8" for both) the cnc does not rectract to the specifide hight. Can anyone verify this?
Thank You.

Nemanja
Nemanja Vujkovic
Senior Member
Posts: 222
Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO

Re: Something is off with outline cut

Post by Nemanja Vujkovic »

Hi everyone,
I was just wondering what was figured on the problem I had. Am i correct in my asamption?
Daniel Vonderheide
Thermwood Team
Posts: 361
Joined: Wed, May 17 2006, 11:25AM
Location: Thermwood

Re: Something is off with outline cut

Post by Daniel Vonderheide »

You are correct. There is an issue with depth cuts right now. If your material thickness is greater than or equal to your max penetration, it does not finish the operation properly. The software engineers know of this issue so it should be fixed in the next release of Control Nesting.
Nemanja Vujkovic
Senior Member
Posts: 222
Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO

Re: Something is off with outline cut

Post by Nemanja Vujkovic »

Thank you Daniel.

Nemanja
Post Reply