Extra assembly????
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Junior Member
- Posts: 38
- Joined: Mon, Aug 08 2005, 5:37PM
- Location: mesa AZ
Extra assembly????
I am cutting a decent size job about 70 sheets for a large office in a house I am doing. After cutting the job my assemblers found an extra assembly. It is a second one for Assembly 1 and the labels say BAC1 for the duplicate parts for A1C1. I went back and checked the room and can't find the assembly anywhere. I know if you can add another assembly when you nest the job but I didn't and it would not put a B in front of the assembly on the labels and I nested the job and did not add any assembly's. Has anyone else had this problem before.
-
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
-
- Junior Member
- Posts: 38
- Joined: Mon, Aug 08 2005, 5:37PM
- Location: mesa AZ
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact: