RN Manual Panel input screen

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Nick M Singer
Guru Member
Posts: 828
Joined: Fri, Jun 17 2005, 12:23AM
Location: South Africa

RN Manual Panel input screen

Post by Nick M Singer »

Is It possible to edit items that are entered in the manual panel input screen? It seems that once you have entered the line item you can not, and have to delete it and start again.
Bill Rutherford
eCabinets Beta Tester
Posts: 386
Joined: Tue, May 10 2005, 5:23AM
Location: Lancaster, NH
Contact:

Post by Bill Rutherford »

Nick,
I have not found any way to edit it. I prefer to use MS Excel to manually input panels if I have more then one or two for just that reason. If I need to make a change it is easy.

Bill Rutherford
Nick M Singer
Guru Member
Posts: 828
Joined: Fri, Jun 17 2005, 12:23AM
Location: South Africa

Post by Nick M Singer »

Hi Bill.
It is as is suspected. the whole entry system is a little clunky maybe the guys at Thermwood can look at a few little improvements like being able to go to an item in the list and make corrections. Pretty please. I suppose you are right about using Exel but sometimes it is nice to have a quick and dirty method to cut a few parts and enter the sizes at the machine
Ryan Hochgesang

Post by Ryan Hochgesang »

I will submit the request to our programmers here, to make the Manual Entry dialogue system easier to edit existing panels.
Post Reply