I'm getting a \"The PLC Program in the Control did not respond to the Tool change request\" error.
Anyone have any ideas? Work arounds? Test ideas?
I've rebooted the control.
Run Rebuild.tm
The error happens repeatedly with T5.
The particular program I'm running starts with T5.
It Does the first T5 operation OK.
Does a change to T8 and it's operation OK.
Changes back to T5 and I get the error.
The tool change appears to complete OK. The router comes up to speed, and I get the error.
I manually inserted T1, and ran the rebuild.tm.
Ran my program and it did the T5 change OK!
First T5 operation OK
T8 change and it's operation OK.
T5 change... and I get the error!
thanks
Tool Change problems
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
-
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
Never Mind....
Never Mind....
Something I did while debugging the code, inserted a macro call into the program that shouldn't have been there.
Regards,
Dave
Something I did while debugging the code, inserted a macro call into the program that shouldn't have been there.
Regards,
Dave
Last edited by David Hall on Sat, Jul 23 2005, 8:00AM, edited 1 time in total.
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact: