Rollin nest 4.61

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand

Rollin nest 4.61

Post by Paul Ford »

Hi all,
Just upgraded to rolling nest 4.61 tried loading a job up which consisted of only 1 cabinet. I then tried to nest a whole job, loaded it pressed ok and then the system froze up. It has done it on a few jobs not just the one.
Any help much appreciated as always
Thanks,
Paul.
Glenn Van Reason
Guru Member
Posts: 459
Joined: Tue, May 17 2005, 4:00PM
Company Name: TBA
Country: AUSTRALIA
Location: ORANGE NSW AUSTRALIA every now and then between trips lol

Post by Glenn Van Reason »

Hi Paul,
Yep same here, I tried nesting four jobs together, as we do here and have had no problems till now, and it froze up, It seems to be taking a very long time loading a job for nesting, the bigger the job the longer it takes.
Looks like it can only handle one job at a time. Yes I have restarted, re installed and checked all updates.

Any patches, suggestions work arounds????

Thanks
Glenn
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand

Post by Paul Ford »

Hi Glenn,
I just went back to v 4.60 until 4.61 is fixed
Glenn Van Reason
Guru Member
Posts: 459
Joined: Tue, May 17 2005, 4:00PM
Company Name: TBA
Country: AUSTRALIA
Location: ORANGE NSW AUSTRALIA every now and then between trips lol

Post by Glenn Van Reason »

For anyone seeing this post the fix has been posted on the Thermwood website....Changes/Additions for v4.62 (7/28/05)


Any chance of notification to users of bug fixes when this happens?????
This was reported on here and I sent emails as well, I have recieved no notification of it being looked at or indeed even fixed, just happened to be watching the website and noticed the update.
Someone has to of read about the problem, then fixed it, then posted it, a quick note on this forum wouldn't go astray.
Jason Susnjara
Thermwood Team
Posts: 1721
Joined: Tue, May 10 2005, 1:26PM
Location: Thermwood
Contact:

Post by Jason Susnjara »

Hi Paul and Glenn,

Can you send me a job that crashes THM software?

thanks,
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand

Post by Paul Ford »

Hi Jason,
I have upgraded to V 4.62 and all is working well now.
Thanks,
Paul.
Post Reply