Hi,
Is it possible or has anyone tried to cut a large Veneer inlay? The attached photo has a Maple Veneer field and in the center a Cherry \"Spark\" Inlay. I have a veneer supplier that can make this at his shop, i was just curious if it could be done on the CNC machine. The Conference table size is around 96\"x36\" Any suggestions or comments would be greaty appreciated!
Thanks
Dave
Inlay Veneer Cut out on CNC
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact:
Inlay Veneer Cut out on CNC
- Attachments
-
- Veneer Inaly.jpg (37.84 KiB) Viewed 3674 times
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
-
- Junior Member
- Posts: 40
- Joined: Tue, Aug 01 2006, 11:27AM
- Location: Quakertown, PA
- Contact: