Does anyone know if this could be corrected through a \"settings\" issue: when I run the nest program and it displays the nest diagrams, the heading (rolling nest savings, rolling nest yield, number of sheets, etc.) is cut off at the top. I'm only seeing the bottom two lines of the heading. And it won't scroll down any.
A image file is attached if you care to look at it.
Thanks,
Mark Wells
Mark Wells Custom Cabinetry
Dothan, AL.
Nest Diagram display
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- New Member
- Posts: 16
- Joined: Fri, May 20 2005, 9:30AM
- Location: Dothan, AL
Nest Diagram display
- Attachments
-
- nest diagram.jpg (139.23 KiB) Viewed 6142 times
-
- Junior Member
- Posts: 37
- Joined: Mon, Dec 26 2005, 11:05PM
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
-
- New Member
- Posts: 16
- Joined: Fri, May 20 2005, 9:30AM
- Location: Dothan, AL
re:nest diagrams
Jason,
My color quality is set to [highest] 32bit and the font size (in the \"appearance\" tab of display properties) is \"normal\". The screen resolution in \"settings\" is 1280x800.
Hope this is enough information for you to help me.
Thanks,
Mark Wells
My color quality is set to [highest] 32bit and the font size (in the \"appearance\" tab of display properties) is \"normal\". The screen resolution in \"settings\" is 1280x800.
Hope this is enough information for you to help me.
Thanks,
Mark Wells
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
-
- New Member
- Posts: 16
- Joined: Fri, May 20 2005, 9:30AM
- Location: Dothan, AL
Jason,
You were right. The first one worked. However, the display is too fuzzy so I'll have to revert to a higher resolution and the nest diagram window being too high.
I'll just try to remember to do what Brent suggested. It works but I'd rather this portion of the program work right.
Thanks for your help,
Mark
You were right. The first one worked. However, the display is too fuzzy so I'll have to revert to a higher resolution and the nest diagram window being too high.
I'll just try to remember to do what Brent suggested. It works but I'd rather this portion of the program work right.
Thanks for your help,
Mark