Warning - DXF users - Nasty bug.

David Hall · Post by **David Hall** » Wed, Nov 22 2006, 2:47PM

I have had two sheets of material end up in the dumpster from this one.

CN 5.07
DXF files
Chain compout layer
Climb cutting

When CN happens to pick a small clockwise arc (any size arc?) portion of the chain to start the cut on, the arc is cut in the counter clockwise; taking a chunk out of the part.

Why doesn't this stuff happen when I'm cutting the cheap stuff?

Regards,
Dave

Larry Epplin · Post by **Larry Epplin** » Mon, Nov 27 2006, 11:26AM

This is addressed in version 5.08.