rotatr countertop in part editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 50
- Joined: Tue, Jun 13 2006, 4:13PM
- Location: NJ
- Contact:
rotatr countertop in part editor
I brought the countertop into part editor to cut out the sink but the countertop appears at an angle on the page . when I try to make a rectangular cutout it is not square to the countertop edge. all other parts I have modified have appeared in part editor square to the page. how do I rotate the countertop on the page so I can make a rectangular cutout?
John
-
- Junior Member
- Posts: 50
- Joined: Tue, Jun 13 2006, 4:13PM
- Location: NJ
- Contact: