Make a column

Paul Huff · Post by **Paul Huff** » Sat, Jan 20 2007, 6:43AM

Ok I am a kid at heart when it comes to some things. Use the dxf or x_t file included in the contours zip to make a column.

Mike Bowers · Post by **Mike Bowers** » Fri, Jan 26 2007, 10:21AM

Nice job Paul
Mike

DanEpps · Post by **DanEpps** » Fri, Jan 26 2007, 10:39AM

Here's your challenge Paul:

Change the flutes to concave instead of convex, give the a flat outer surface and make the columns fatter at the bottom than the top--like Greek marble columns.

That would be a REAL feat to accomplish!

Brian Shannon · Post by **Brian Shannon** » Fri, Jan 26 2007, 10:48AM

Go Paul, Go! You're an animal!

David Norton · Post by **David Norton** » Fri, Jan 26 2007, 8:08PM

Damn this is what came to mind when I saw this. Would love to have a .tol file that cut that profile.................hehehe!

Mike Bowers · Post by **Mike Bowers** » Fri, Jan 26 2007, 8:19PM

Welcome back Dave !

David Norton · Post by **David Norton** » Sat, Jan 27 2007, 8:19AM

Thx Mike, yea it's been awhile.

Paul Huff · Post by **Paul Huff** » Sat, Jan 27 2007, 8:28AM

Hmmm that might be possible with the right tol. I might give that a try.