Hard drive bad

Matt Quarles · Post by **Matt Quarles** » Wed, Feb 21 2007, 11:09AM

I have a machine that the hard drive went bad in but I can still read it to get data off of it. Where are the files that contain the tool table information so I can grab them from the old one and put in the new one. Anybody ever done this?
thanks in advance

Ryan Hochgesang · Post by **Ryan Hochgesang** » Wed, Feb 21 2007, 11:20AM

Hi Matt,

The file that contains all settings for Tool Management on your THM control is called Toolman.thm and is located in C:\\System directory.

Let me know if you have any additional questions or concerns.

Brian Shannon · Post by **Brian Shannon** » Wed, Feb 21 2007, 11:23AM

I need to replace mine too. My \"C\" drive partition is full. Talk to Ryan at Thermwood. He emailed me a list of the files that would need to be saved. Let me know how it goes. I'm just to chicken to do it. I guess I should before I am at a point were I can't use the router.

Brian

Brian Shannon · Post by **Brian Shannon** » Wed, Feb 21 2007, 11:24AM

These guys are good...

Matt Quarles · Post by **Matt Quarles** » Wed, Feb 21 2007, 11:28AM

Hey Ryan can I get that list of files that would be helpful thanks.

Ryan Hochgesang · Post by **Ryan Hochgesang** » Wed, Feb 21 2007, 11:50AM

Files containing customized settings on your 91000 Super Control
(THM versions 5.0 and Up):

- C:\\Rolling Nest\\machine.ini
- C:\\Rolling Nest\\tools.thm
- C:\\Rolling Nest\\material.mdb
- C:\\system\\toolman.thm
- C:\\offset.tab
- C:\\MACROS
- D:\\DATA