V5.1 Error adding doors

DanEpps · Post by **DanEpps** » Thu, Mar 01 2007, 12:32PM

Base cabinet, sheet stock face frames with puzzle joints...

When trying to add CRP-10 double doors I am getting the error in the attached image.

DanEpps · Post by **DanEpps** » Thu, Mar 01 2007, 12:42PM

Update: I removed all part editor cuts from the cabinet and was able to add the doors. I was then able to put part editor cuts back on the cabinet.

Additional information: The CRP-10 doors we configured with a C profile and were inset into the face frames.

Scott G Vaal · Post by **Scott G Vaal** » Thu, Mar 01 2007, 12:47PM

Dan,

Can you please post the cabinet the way it was when you were getting the message? Thanks.

DanEpps · Post by **DanEpps** » Thu, Mar 01 2007, 12:53PM

I don't have it anymore but if you try to remove the doors from this one you will get the same error.

Walker T Scott · Post by **Walker T Scott** » Thu, Mar 01 2007, 1:14PM

Dan,

What kind of parte editor cuts did you have on the cabinet and where?

Thanks

DanEpps · Post by **DanEpps** » Thu, Mar 01 2007, 1:27PM

This cabinet has all of the cuts on it. The top has a profiled edge, both ends and both face frame stiles are raised using MDF assymetric #4.

Removing the cuts did not help though until I saved the cabinet WITHOUT the cuts. Once I did that I could add the doors and cuts back to the cabinet.