Has anyone put drawers in the back of a blank corner cabinet.
If so did your customer have any remarks about it.
Now that I look at the picture I think the sides of the drawers are to
high. They are 6 in high now?
Drawers in blank corner cabinet
Moderators: Jason Susnjara, Clint Buechlein
-
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
-
- Senior Member
- Posts: 103
- Joined: Wed, Jan 10 2007, 9:53PM
- Company Name: Grali inc.
- Location: lilburn,ga
- Contact:
-
- Wizard Member
- Posts: 4719
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
-
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
-
- Senior Member
- Posts: 222
- Joined: Sun, Dec 11 2005, 1:22PM
- Location: Kennedale, Texas
- Contact:
Unless you had a pull out in front of the back drawers and raised the back drawers up a little to clear the slides of the front drawer.
Lamar Horton
http://www.jlcustomcabinets.com
http://www.jlcustomcabinets.com
-
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
-
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
-
- Senior Member
- Posts: 222
- Joined: Sun, Dec 11 2005, 1:22PM
- Location: Kennedale, Texas
- Contact:
I have been pondering a solution for this situation for a long time and was not able to come up with simple answer. All of the pre-fabed insets for corner cabinets are outragesly priced, although I see why. I have dreamed up some pretty elaborate contraptions that, in reality, would probably not hold up over time. It wasn't until I saw your drawing that the light went on. Thanks
Lamar Horton
http://www.jlcustomcabinets.com
http://www.jlcustomcabinets.com