Hello,
This is my first post. I have used eCab since ver. 2, but just joined the forum. Most of my work is in remodeling or in matching existing cabinets or duplicating something the customer already has. I have not used all of the features, but, I'm trying to learn. My question today is about holes associtated with hinges. When sclecting a hinge and associating a hole pattern, the file reads something like this:
\"hinge-Salice-Series200-bore_3.ptn\". Is the the number at the end, in this case a 3, the tab distance on the door?
This software is the best and Thanks to Eric and Thermwood I have my software running again.
Thanks
Doug
Associate Holes
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 4
- Joined: Sat, Feb 10 2007, 5:46PM
- Location: Henderson, NV
-
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
-
- New Member
- Posts: 4
- Joined: Sat, Feb 10 2007, 5:46PM
- Location: Henderson, NV