Stretchers

Jean G Voyer · Post by **Jean G Voyer** » Tue, May 08 2007, 3:00PM

In built 3 putting in stretchers make the program shut down.

Joe Dusel · Post by **Joe Dusel** » Tue, May 08 2007, 3:23PM

I just put about 5 different stretchers into a standard base using V5.1.3 without a problem. Is this a problem with a specific cabinet, or have you also had this problem with the standard cabinets?

Joe

Jean G Voyer · Post by **Jean G Voyer** » Tue, May 08 2007, 4:10PM

It happened twice with the same cabinet.
I tried to put a 4\" stretcher across and right away after I pushed 'Add stretcher' the program shut down.
It's in a base cabinet made out of a standard cabinet which I change the generic material for 3/4\" birch ply.
When I have a minute I will try again and try to note the steps taken.

Al Navas · Post by **Al Navas** » Tue, May 08 2007, 4:43PM

Jean,

Could you post the troublesome cabinet? Thanks!

Jean G Voyer · Post by **Jean G Voyer** » Wed, May 09 2007, 8:20AM

I tried this morning and it worked.
My computer must have been tired yesterday.
A good night sleep fixes a lot of things.