Edgebanding logo an stickers for backs

Ryan Osburn · Post by **Ryan Osburn** » Fri, May 25 2007, 3:04PM

Iam getting the edgebanding logo on cabnets and drawers for there backs even though I dont have edgebanding on any part of the drawer. its not all of them it seems to be just evry now and then why?

Todd Miller · Post by **Todd Miller** » Tue, May 29 2007, 7:42AM

Ryan,
Have you checked in the Edgebanding editor to see if the edgebanding has been applied to those areas or not? If so, post the cabinet and we can take a look at it. Thanks!

Also, what version of Control Nesting are you running?