We were cutting some parts of which three required a flip operation. We got through the first two parts fine but when we scanned the third part we got an error saying label not found. I looked at the code (attached) and saw that the \"IF\" statement was there for the part and had the right label number complete with a CALL to the subroutine, however, the subroutine was nowhere to be found in the program.
IF [FILENAME$=\"R01P0002\"] THEN M82L4
IF [FILENAME$=\"R01P0001\"] THEN M82L5
IF [FILENAME$=\"R01P0006\"] THEN M82L6
A string search for \"L4\" only returns the IF statement not any subroutine. A search for \"L5\" or \"L6\" will find both the IF statement and the subroutine.
We are running v4.63 of Rolling Nest.